Assessment
Construction, movement and surface access define the approach.
Item type gives a starting point, but construction determines the handling. Hinges, catches, hollow sections, soldered links, sharp detail and stone-set areas can all limit access or change the safe polishing sequence.
Pairs and linked items are kept together under one reference. Any part that must remain satin, engraved, oxidised or deliberately textured should be identified in the brief.
At the bench
Each component is finished in context with the complete piece.
- 01
Identify
Record pairs, removable components, catches and sections with different finishes.
- 02
Inspect
Check joints, hinges, links, stones and thin areas before surface work begins.
- 03
Finish by section
Use suitable access and control for the construction rather than treating the whole item as one flat surface.
- 04
Reassemble and check
Clean, refit components where agreed, and inspect operation and finish.
Job specification
Moving parts and protected finishes require clear identification.
- Item type and quantity
- Metal combination
- Required finish by area
- Moving or removable components
Keep pairs and removable components under one reference, and mark any engraving, texture or contrast finish that must remain unchanged.
Trade pricing
Item type gives the starting rate; construction decides suitability.
The standard schedule lists starting prices for bangles, bracelets, earrings and pendants by metal and rhodium requirement. Size, construction, stone setting and condition determine whether the standard starting rate is suitable.
Prices exclude VAT. Matched quantities can be reviewed together when condition and finish are consistent. VAT is added at the applicable rate.